These are the ball joints used on the Cub Lo-boy 154.

This is the felt washer that goes next to the front axle seal.

There are 4 of these bearings on the front axle; one on each side of each hub.

Get a grip with this good looking imitation leather, steering wheel cover. Fits 14.5 to 15.5 steering wheels.

Lower Radiator / Steering Gear Housing For Farmall Cub & Cub Loboy Does not fit 154, 184 or 185. Includes the steering worm shaft bushing and the steering sector bushing. Both are installed. 2- 1/4" freeze plug not included. Threaded water pipe not included Cub Cub Loboy

NOT CURRENTLY AVAILABLE

Thsi is a NOS (new old stock) steering arm for a 100, 130, 140. Made in the USA

OUTER TIE ROD END --- 15 3/4" LONG, 0.920 DIAMETER, 6 NOTCHES --- International Applications: LATE H, SUPER H, M, MD, SUPER M, SUPER MD, MTA, SUPER MTA, 300 ROWCROP, 350 ROWCROP, 400, 450, 460, 544, 560, 656, 666, 686, 706, 756, 766, 786, 806, 826, 856, 886, 966, 1026, 1066, 1086, 1206, 1256, 1456, 1466, 1468, 1486, 1566, 1568, 1586, HYDRO 70, HYD --- Replacement Part #: IH: 359984R93

This is a steering cylinder on a 1066. This is the pin style so be to sure to check which style end you have. Pin or tie rod?

SOLD EACH. These shims come in 3 thicknesses, .007, .010 and .060. These shims are for Cubs and Cub Lo-Boys (serial number 4801 and below). These shims adjust the tie rods at the steering arm. Made in the USA

STEERING ARM KNUCKLE SET SCREW --- COARSE THREAD --- USA MADE --- International Applications: CUB (SN 501 - 118687) --- Replacement Part #: 43528D

This is the bottom of two gaskets that go into the steering box.

This the top of two gaskets that go in the steering box.

This bushing goes in the steering box where the steering wheel shaft enters the steering box.

STEERING WHEEL --- HUB IS SPLINED HALF WAY THRU, NOT ALL THE WAY THRU THE HUB. 36 SPLINES --- LIKE ORIGINAL, ALL NEW MATERIAL, STEEL SPOKES --- 16" DIAMETER --- 7/8" SHAFT --- 3 COVERED TO CENTER SPOKES --- International Applications: TRACTORS WITHOUT TILT STEERING: 404, 424, 444, 454, 464, 484, 504, 544, 574, 584, 606 , 656, 664, 666, 674, 684, 686, 706, 756, 766, 784, 786, 806, 826, 856, 884, 886, 966, 986, 1026, 1066, 1086, 1206, 1256, 1456, 1466, 1486, 1566, 1568, 1586, 21026, 21256 --- Replacement Part #: 385156R1

STEERING WHEEL --- 20" DIAMETER, KEYED & TAPERED HUB, 3/4" SHAFT, 4 SPOKES --- LIKE ORIGINAL, ALL NEW MATERIAL, STEEL SPOKES --- International Applications: M, MV, MD, MDV, SUPER MDV, SUPER M, SUPER MV, SUPER MD, W9, WD9, I9, ID9, WR9, 400, 450, 600, 650 (ALL W/ 4 SPOKE) --- Replacement Part #: IH: 557282R91

Tilt Steering Wheel 16" Diameter, 7/8" 36 Splined Hub. Fit Tractors: 706, 756, 766, 806, 826, 856, 956, 1026, 1066, 1256, 1456, 1466, 1468, 1566, 1568, HYDRO 100 USE With Cap 26146.

STEERING WHEEL CAP --- 2.511 O.D. --- International Applications: CUB LO-BOY: 154, 184, 185; -- CUB CADET: 111, 1100 (SN 400001 & UP), 382, 482, 982 (SN 665001

3 Spoke 17-5/8" Steering Wheel With 3/4" Keyed Shaft For Farmall 100, 130, 200, 230, 300, 400, C, H, HV, M, MD, MDV, MV, Super, A, Super AV, Super C, Super H, Super M, Super MTA. Replaces IH PN#: 29118DC

STEERING WHEEL NUT --- PLAIN FINSIH 5/8 X 18 --- International Applications: 111, 1100 CUB CADET (SN 400001 & UP), 382, 482, 982 (SN 665001 & UP), 154, 184, 185 --- Replacement Part #: IH: 124944

Do you have a leak around your steering wheel shaft? This seal will fix it.

Steering Wheel Spinner. Fits most Steering wheels. All hardware included.

Steering Wheel Worm Shaft Seal for Farmall C this is the first seal under the steering gear between the bearing and steering worm wheel.

Steering Worm Bushing for Farmall C.

Steering Worm Nut for Farmall C. This is the nut that is in front of the steering gear box that holds the steering worm shaft and steering wheel shaft together.

U-BOLT SET --- U-BOLT SET INCLUDES: 2 U-BOLTS, 4 NUTS & 4 WASHERS. MOUNTS HEADLIGHT BAR TO STEERING COLUMN. --- USA MADE --- International Applications: H, HV, M, MV, MD, MDV, MTA, SUPER H, SUPER HV, SUPER M, SUPER MV, SUPER MD, SUPER MDV, SUPER MTA --- Replacement Part #: IH: 59468D

Woodruff key for Farmall C. This is the Woodruff key that holds the steering shaft into the steering shaft u-joint. This Woodruff key also is the Woodruff key that holds the steering worm shaft into the steering gear box.