This is the outer bearing on the flat belt pulley drive.

Dual PTO Drive Pulley For Farmall Cub Lo-Boy 154. Replaces International Part Number#: 404932r2

Thsi fits the following tractors Hydro 84, 2400, 248, 258, 268, 278, 385, 395, 4210, 4230, 4240, 454, 464, 474, 484, 485, 495, 574, 584, 585, 595, 674, 684, 685, 695, 784, 785, 884, 885, 895, 995.

This fits the following tractors; Hydro 84, 2400, 248, 258, 268, 278, 385, 395, 4210, 4230, 4240, 454, 464, 474, 484, 485, 495, 574, 584, 585, 595, 674, 684, 685, 695, 784, 785, 884, 885, 895, 995.

Part Reference Numbers: 3041319R11;751471R91 Fits Models: 2300 INDUST/CONST; 354 TRACTOR; 424 TRACTOR; 444 INDUST/CONST; B250; B275; B414; BC144 ENG; BD144A ENG; BD154 ENG; C146 ENG

6 spline w/ 1 3/8"OD by 8 spline w/1 1/2" OD. length over all 27". Part Reference Numbers: 3073111R91 Fits Models: 384 TRACTOR; 444 INDUST/CONST

Part Reference Numbers: 3064230R91 Fits Models: 2300 INDUST/CONST; 2350A TRACTOR; 276 TRACTOR; 354 TRACTOR; 364 TRACTOR; 434 TRACTOR; 444 INDUST/CONST; B414

Part Reference Numbers: 751115R92;751115R91 Fits Models: B275

Part Reference Numbers: 751113R2 Fits Models: B275

Part Reference Numbers: 5397S;A57250 Fits Models: 1030 TRACTOR; 1070 TRACOTR; 1175 TRACTOR; 1896 TRACTOR; 2090 TRACTOR; 2094 TRACTOR; 2096 TRACTOR; 2290 TRACTOR; 2294 TRACTOR; 380B INDUST/CONST; 580B INDUST/CONST; 730 SWATHER/WINDROWER; 770; 830; 870; 930; 970

PTO shaft snap ring and flat belt pulley shaft snap ring.

This is the shaft seal in the power take off drive The unit uses two seals.

This is the pair of belts that run from the driveshaft to power the PTO shaft. They are midship. They must be replaced as a pair.

These come as a pair and need to be changed as a pair. They power the PTO shaft.

PTO SHAFT for CUB, CUB LO-BOY

0.750" Bushing I.D. with (2) 3/16" Pin Hole I.D. 0.380" Top Pin O.D. 0.965" Bracket Width. 2.610" O/A Length

SLIP FIT COUPLER (FOR TRACTORS THAT NEED A U-JOINT) --- WHEN EQUIPPED WITH CHAR-LYNN ADD-ON POWER STEERING -- USE THIS COUPLER IF A UNIVERSAL JOINT IS NEEDED ON THE STEERING SHAFT --- International Applications: IH MODELS