NOTE: This is a special order item. 2 weeks to ship. The Farmall 100, 130, 140 came with a 1 point hitch system that can now be easily adapted to a 3 point sytem using this hitch kit. If you have a 1 point hitch and would rather have 3 point connections to run a mower or other implement, the kit will work for you. 2 week build time on all orders.

This is a spindle bearing for the 3160 mower deck that is used on a Cub Lo-Boy 154. It takes 2 bearings per spindle and there are 3 spindles.

This seal is the spindle seal for a 3160 mower deck that goes on a cub Lo-Boy 154. It takes 2 seals per spindle and there are 3 spindles.

Belt Pulley Drive Shaft Oil Seal For Farmall Cub. Replaces Ih#351276r91

Cub & Cub lo-boy PTO shift collar

This is the lever needed to engage the PTO on your Cub.

Dual PTO Drive Pulley For Farmall Cub Lo-Boy 154. Replaces International Part Number#: 404932r2

Fits Farmall Super C, 200, 230 240. Farmalls with C123 Engine.

Specifications 0.500" shaft diameter 1.124" outside diameter (metal case) 0.250" width Nitrile Rubber lip material (NBR)

PTO shaft snap ring and flat belt pulley shaft snap ring.

This bearing is on the lower PTO shaft and takes two bearings. So check to see the condition of both bearings.

If you have a sickle mower on your Cub and it has the 4-1/2" PTO pulley this is the belt you need to get your mower running.

This gasket fits fits on the oil pump housing cover.

The paper belt pulley was driven by a PTO mounted atop the Farmall W-6 transmission, this PTO had an 8-bolt mount. Replace your worn or oil soaked pulley for a nice rebuilt one. This pulley is 12" X 8.75" and weighs 25 pounds. Made in the USA

Quiet the bearing noise in your PTO with this bearing.

PTO BEARING RETAINER GASKET --- International Applications: CUB, CUB LOBOY --- Replacement Part #: IH 351258R2

This is the pair of belts that run from the driveshaft to power the PTO shaft. They are midship. They must be replaced as a pair.

Specifications 1.495" wide 0.120" thick 2 used per tractor; sold individually Learn about the Steiner Difference This brake band is 1.495" wide and the lining is 0.120" thic Super M with planetary PTO; ''late''; SN: 60001 and up Super MDV-TA with planetary PTO MTA with planetary PTO Super MTA with planetary PTO Super MTA with planetary PTO; diesel Super MVTA with planetary PTO Super W6TA with planetary PTO 300 with planetary PTO 330 with planetary PTO 340 with planetary PTO 350 with planetary PTO 400 with planetary PTO W400 with planetary PTO Wheatland 450 with planetary PTO W450 with planetary PTO Wheatland 460 with planetary PTO 560 with planetary PTO 660

This bearing is part of the independent PTO and is for the PTO cam bearing..

This gasket goes on the cover for the PTO driaven gear cover.

This gasket fits the PTO cover. If the tractor is an A, it fits tractors with serial number 66671 and above.

This gasket fits the PTO cover. If the tractor is an A, it fits tractors with serial number 66671.

These come as a pair and need to be changed as a pair. They power the PTO shaft.

Does the PTO housing leak? Here is the big gasket to fix it.

PTO input shaft bearing

This is the seal you need to fix the leak on your PTO shaft.

PTO output oil seal.

Oil seal that goes around your PTO shaft.

Leaking PTO shaft? Here is the gasket to fix it.

This is the front bearing on the PTO shaft.

PTO Shaft 2.1 lbs. PTO Shaft IH International Harvester Cub 10/6 spline , 11.54 inches long. 1" with 10 spline